HVAC & refrigeration technician in Madinat Al Sultan

The technician brings pressure gauges to check the refrigeration cycle, electrical meters to test the capacitor, relay and control board, and leak detection and flare joint tools. The exact kit depends on the fault description you give when you book.

Yes. The technician covers both air conditioning and refrigeration, so if you have a faulty AC and a commercial fridge or cold unit at the same location he inspects both in one visit and explains the condition of each separately before any repair begins.

The technician diagnoses the fault first, whether a failing capacitor, a deteriorated flare joint or a blocked drain line, then tells you what he found, what work is needed and which parts must be replaced. No work starts until you have approved what he has explained.

After the inspection the technician names the part needed and explains why. If the part is available on site the repair is done in the same visit. If it has to be sourced first, he agrees a second visit with you. No replacement is started without your knowledge of what will be done.

Yes. A split unit gives direct access to the coil, filter and flare joint. A ducted or cassette unit also needs the plenum, dampers and duct runs checked to confirm air is distributed correctly. The technician decides the inspection method after seeing the unit type and installation at your site.

The technician checks refrigerant level, pressure, copper lines and insulation, which could reveal low charge during install, poor insulation or a compressor fault.

The drain pan could be blocked or the fan weak, so the technician cleans the pan and coil and checks the fan and airflow around the indoor unit.

Yes, salt corrodes copper lines and wiring, so we clean them regularly and inspect every six months to catch corrosion early.

The technician checks the compressor, coil, valve and refrigerant, which could indicate low charge, a leak or weak valve, and explains the fix before starting.