Central AC installation in Al Hamdaniyah

We calculate the thermal load for each zone based on its area, ceiling height, number of external openings, orientation and how it will be used. In Jeddah the sun's effect on west-facing facades is significant, and high humidity goes into the calculation. We choose the unit size after this calculation, not before.

We fabricate round and rectangular ducts in our own workshop from G90 galvanised sheet or aluminium sheet depending on what the project needs. This lets us cut ducts to the exact site dimensions and fit them tightly, avoiding ill-fitting sections that leak air and raise electricity consumption.

We use Mueller copper in runs of up to 30 metres without welded joints, which reduces potential leak points. If a run exceeds that, the survey determines whether the outdoor unit position needs rethinking or whether the refrigerant charge needs adjustment according to the type shown on the unit's nameplate.

Yes, and it is settled at the design stage. Each floor can have its own unit, or the network can be split into zones with dampers and a thermostat in each, so you do not cool the whole upper floor while the family sits in the majlis. We recommend the right option after the load calculation.

Yes, and the roof surface determines what kind of base is needed. For villas we fabricate a raised steel frame that keeps the unit clear of pooled rainwater and allows airflow beneath it. The exact height and angle depend on the roof pitch and the condensate drain position, which the site survey establishes. The aim is to keep the unit level and to prevent vibration movement during operation.

Yes, we design the network flexibly to allow new ducts and distribution vents to be added later. We leave you with a complete plan showing available space and possible future expansion points.

We calculate the load for each flat based on room count, size and windows, then design separate branches from the main network to each flat with dampers that control the flow. This ensures each flat receives the correct air volume.

Yes, dust and salt accumulate quickly on outdoor surfaces and exhaust vents. We choose strong, protected exhausts and regularly clean air intakes. We provide customers with a maintenance schedule to maintain performance.

All copper runs are insulated with thick foam tape and wrapped with thermal protection against heat and humidity. We inspect every joint before sealing and test the full system to confirm no leakage or pressure loss.