Central AC for apartments
Apartment central AC in Jawharat Thuwal
In Jawharat Thuwal, far north Jeddah, where modern villas and spacious flats spread across sloped terrain, central AC needs specialist planning for multi-level floors and high ceilings. Alrabih's team designs a system that suits the terrain and the district's contemporary architecture.
- Tight ceiling
- Sealed drain
- Quiet running
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
When central AC makes sense in your flat
- 1
New flat before finishing
The finishing stage is the right time to install central AC. The ceiling is open and walls are ready for copper and drain routes, so there is no need later to cut plaster or damage finished surfaces.
- 2
Occupied flat where splits fall short
If splits leave hot and cold patches, or the noise bothers you at night, central AC distributes air evenly and hides the unit away from the room. A site survey decides whether your ceiling height allows it.
- 3
Your unit disturbs the neighbours
In apartments, neighbours hear unit vibration through shared ceilings and walls. We choose the indoor unit suspension point carefully and use flexible collars on the air outlets to absorb vibration before it reaches the building structure.
Who it's for
Living in a furnished flat and want to replace splits
We survey your ceiling void to see whether a concealed unit fits, then run copper and drain without disturbing the existing décor.
Ask on WhatsAppBuying a flat in a building under construction
We coordinate with the finishing stage to run copper, drain and ducts before ceilings and walls are closed, so every route stays fully concealed.
Ask on WhatsApp
What the installation covers
- Ceiling survey and unit position
- Mueller copper fully insulated
- Condensate drain with correct fall
- Air ducts and distributed outlets
- Line vacuum and start-up test
How we work
How we work
- 1
Ceiling and route survey
We measure the available ceiling void, decide where the indoor unit hangs, map the copper route and find where condensate drains without causing damp. The survey decides whether one zone or more suits the flat.
- 2
Run copper and drain
We run insulated Mueller copper in the void above the suspended ceiling and slope the condensate line towards the building drain or an external outlet, so no standing water causes odour or damp.
- 3
Fit ducts and outlets
We mount the indoor unit on vibration-absorbing hangers, route ducts to each room and place every outlet so air spreads evenly without blowing cold air directly onto anyone.
- 4
Vacuum, test and hand over
We vacuum the copper line to remove air and moisture, check all joints, then run the unit and confirm cooling in every room before we hand over.
A considered install or a hasty one?
| Alrabih | The usual way | |
|---|---|---|
| Indoor unit position | Set after measuring the void | Wherever it fits |
| Condensate drain | Calculated fall to building drain | May pool and cause damp |
| Vibration | Absorbing hangers, flexible collars | Reaches the neighbours |
| Air distribution | Outlets placed for even spread | Cold rooms and warm rooms |
| Salty sea air | Mueller copper, tight flared joints | Early joint corrosion |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.

Split AC installation
Request this service
Duct installation
Request this service
Central AC installation
Request this service
Duct fabrication
Request this service
Cold room installation
Request this service
Electro-mechanical works
Request this service
Chiller & AHU installation
Request this service
HVAC design
Request this service
AC repair & faults
Request this service
AC cleaning
Request this service
Refrigerant charging
Request this service
Central AC maintenance
Request this service
Chiller maintenance
Request this service
AC removal & refitting
Request this service
Duct cleaning & sanitising
Request this service
AC servicing by brand
Request this service
Operation & maintenance contracts
Request this service
AHU maintenance
Request this service
Fridge & freezer service
Request this service
Cold rooms
Request this service
Display fridges & chillers
Request this service
Factory HVAC
Request this service
Warehouse HVAC
Request this service
Villa & home HVAC
Request this service
Hotel HVAC
Request this service
School HVAC
Request this service
Hospital HVAC
Request this service
Mosque HVAC
Request this service
Mall & retail HVAC
Request this service
Restaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.

What sets this district apart
Jawharat Thuwal is a relatively modern area in far north Jeddah, marked by luxury villas and spacious flats with contemporary design, very high ceilings, and open-plan living. The sloped terrain means each villa or apartment block sits at different elevations, complicating ductwork and pipe routing. The nearby coastal location brings high humidity and salt-air exposure, so robust insulation and effective condensate drainage are essential.
Jawharat Thuwal is a modern upscale district in far north Jeddah, with sloped terrain and contemporary villas and flats with high ceilings.
Most villas and large flats here need a central system with three or more zones, with the outdoor unit on elevated ground or a roof sheltered from sea winds.
The AC setup in Jawharat Thuwal
- 1
Multi-level central system with separate units
Separate indoor units per villa level distribute cool air efficiently without pressure loss over long vertical distances.
- 2
Copper pipes protected from salt and moisture
All copper pipes are wrapped in thick insulation with sea-salt-resistant coating, and each end is capped with a sealed metal cover.
- 3
Robust outdoor unit on sturdy concrete base
The outdoor unit sits on a strong concrete base with high-spec metal bolts, in a sheltered roof or garden spot.
Before the visit
Before our visit in Jawharat Thuwal
- 1
Get architectural plans showing all levels and elevations
Save complete architectural plans showing floor levels, elevations, and openings for the team to study before the visit.
- 2
Designate a strong, secure spot for the outdoor unit
Choose a roof or garden spot sheltered from sea winds with solid construction, and confirm adequate ventilation space around it.
- 3
Confirm safe access routes to all unit locations
Verify that the team can safely reach all indoor units on every level and the outdoor unit without hazards.
More districts for Apartment central AC
Other services in Jawharat Thuwal
FAQ
Questions about Apartment central AC
Is there enough ceiling space in a flat for a central unit?
It varies between flats. Slim ceiling cassettes need less void depth than full ducted units. A site survey measures what is available and decides the right type; if the corridor ceiling is too shallow we look at a storage room or bathroom ceiling instead.
Is one unit enough for the whole flat or do I need more?
It depends on the flat's area, room layout and how much sun each side receives. Two- and three-bedroom flats can sometimes work with one unit and well-planned ducts; larger flats or those with separate zones may need two. The survey decides.
Where does the outdoor unit go when the flat has no large balcony?
Options include the shared roof if the building rules allow it, a facade bracket away from neighbours' windows, or the balcony if it can take the load. We review the building's rules before recommending any position.
Jeddah's air is very humid; does that affect the condensate drain?
Yes. In Jeddah the indoor unit produces more condensate because of the high humidity. We make sure the drain line has enough fall, that the horizontal run before it drops is not too long, and that the outlet does not conflict with other flats' drainage in the building.
Can the flat be split into two zones with different temperatures?
It is possible using two separate indoor units or by adding variable-flow dampers on the duct runs. The right choice depends on the flat's layout and the ceiling void available in each zone. A site survey decides which approach suits your room arrangement.
My villa is on a slope, how do you distribute air across different levels?
We survey the actual floor levels during the visit and install separate indoor units per level or run strong vertical ducts to overcome the elevation difference.
The ceilings are very high, does this increase energy use?
Yes, high ceilings need stronger units or multiple zones. We study the room volume and height to select the right-capacity unit.
Sea humidity and salt affect the copper lines, how do you protect them?
We use thick copper insulation with salt-resistant coating, and terminate pipes with a sealed metal cap to block salt and moisture entry.
The sea winds are very strong, are there problems mounting the outdoor unit?
We mount the unit on a sturdy concrete base with high-spec metal bolts, and select a sheltered spot on the roof or between garden walls.












































































