Concealed central AC in Al Rawabi

Through the dedicated access panel in the plasterboard. If the panel is there and directly in front of the unit, the technician goes straight in. If it is missing or in the wrong place, we mark the right position and cut it cleanly without touching the rest of the ceiling.

The two most common causes in Jeddah are a drain line blocked by algae that grow in the high humidity, and a dry trap that lets air in and stops the water moving. Both can be fixed without replacing the unit, provided there is no mechanical damage.

Yes, a concealed unit sits in a closed void with little ventilation, so more condensate collects on the drain pan than in an exposed unit. That makes the drain line and trap more likely to block or dry out, and keeping them clear matters more here than for any other unit type.

The depth needed varies with the unit type and dimensions, and only a site survey decides. If depth is borderline, we check whether the plasterboard ceiling can be dropped slightly in the unit zone. If that is not possible, we suggest a better fit for the room size and ceiling height.

Yes, the unit body needs a certain height, and on top of that the drain line must slope continuously from the unit to the discharge point. The actual void depth required depends on the unit type, the drain run length and where the discharge is; only a site survey gives the exact answer.

Yes, even new systems collect dust and moisture, and we recommend cleaning the coils and drain once or twice yearly to keep efficiency and drainage working well.

Weak airflow can signal a partial blockage in a distribution duct or low pressure from the main unit, and our inspection pinpoints the cause.

Yes, humid air increases condensate volume noticeably, and drain blockages are common in damp areas, so we clean the pan and line regularly.

Built-in service panels allow safe access to the coils and drain, and our team is trained to open and seal these panels without damaging the plasterboard or electrical fixtures.