Factory HVAC in Al Rimal

Yes, and we do it often. We design spot cooling for workstations or worker walkways using independent units or directed duct runs, rather than trying to cool the entire building volume. The right approach depends on the site and the process, and the survey decides it.

We select units with a protection rating suited to the industrial environment and route airflow away from dust sources where the layout allows. In scheduled maintenance we inspect and clean coils, compressors and filters before deposits build up and affect unit performance.

Yes, in our own workshop we fabricate round and rectangular duct to any size the design calls for, from G90 galvanised or aluminium sheet to SMACNA standards, including plenums, transitions and dampers needed to control air distribution.

Yes, when we set up the preventive maintenance contract we agree times that fit your production schedule, whether between shifts or on rest days. The aim is that production lines are never stopped because of maintenance work.

Process ventilation targets heat and fumes produced by machinery and production lines, using exhaust fans and calculated fresh-air inlets sized to the heat load at each source. Worker-zone air conditioning aims to maintain a tolerable temperature at floor level without cooling the full volume of the building. A site survey of each factory decides which approach fits each area.

Yes, we use high-capacity equipment and heat-resistant steel, with outdoor units placed for good airflow and partial shade where possible.

We fit multi-stage filters, a coarse first stage for large dust and a fine one after, with frequent cleaning schedules because desert dust clogs rapidly.

The system is designed for continuous operation, but regular filter and coil cleaning is essential to maintain efficiency, and we include a maintenance schedule in the contract.

We insulate pipes with UV- and dust-resistant materials, route them covered where possible, and inspect them at every maintenance visit.