Factory HVAC in Mushrifah

Yes, and we do it often. We design spot cooling for workstations or worker walkways using independent units or directed duct runs, rather than trying to cool the entire building volume. The right approach depends on the site and the process, and the survey decides it.

We select units with a protection rating suited to the industrial environment and route airflow away from dust sources where the layout allows. In scheduled maintenance we inspect and clean coils, compressors and filters before deposits build up and affect unit performance.

Yes, in our own workshop we fabricate round and rectangular duct to any size the design calls for, from G90 galvanised or aluminium sheet to SMACNA standards, including plenums, transitions and dampers needed to control air distribution.

Yes, when we set up the preventive maintenance contract we agree times that fit your production schedule, whether between shifts or on rest days. The aim is that production lines are never stopped because of maintenance work.

Process ventilation targets heat and fumes produced by machinery and production lines, using exhaust fans and calculated fresh-air inlets sized to the heat load at each source. Worker-zone air conditioning aims to maintain a tolerable temperature at floor level without cooling the full volume of the building. A site survey of each factory decides which approach fits each area.

We use hybrid systems with separate controls in different zones, allowing precise adjustment per production area. We install high-accuracy thermostats to prevent fluctuation.

No, we need smart distribution with extra outlets near hot electrical zones, and sometimes local supplementary cooling units to prevent heat pooling.

We use supplementary dehumidifiers where needed in sensitive zones, monitoring relative humidity within the recommended range for each production type.

We design systems with flexibility to add outlets or local units later. We recommend understanding future expansion plans before final design.