Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
When your freezer needs attention
- 1
The freezer is not freezing hard
Products feel soft or partly thawed even though the freezer is running. The cause may be the thermostat, the compressor, the refrigerant charge or the temperature sensor circuit. A site diagnosis tells you which one needs fixing.
- 2
Ice building up and not defrosting
A thick ice layer on the freezer wall or evaporator points to a fault in the defrost cycle, whether in the defrost heater, timer or sensor. Left alone, the build-up strains the compressor and steadily raises electricity use.
- 3
A door that will not seal or a unit that keeps alarming
A worn door gasket lets warm humid air in constantly, building ice and pressing the compressor harder. We check the gasket, the door frame and the alarm switch to find the cause of repeated alarms and put it right.
Who it's for
Your home freezer has stopped freezing hard
We diagnose the fault at your home, whether in the compressor, thermostat or door gasket, and advise you on keeping the contents safe while we work.
Ask on WhatsAppYour shop freezer is alarming and stock is at risk
We check the defrost cycle, door gasket and compressor at your shop, and give practical guidance on protecting frozen stock throughout the repair.
Ask on WhatsApp
What the work covers
- Compressor and capacitor check
- Defrost cycle and sensor test
- Refrigerant pressure reading
- Door gasket inspection
- Stock-handling advice during repair
How we work
How we work
- 1
Describe the fault
Send us the freezer type, the fault you have noticed and your district, and we tell you what the technician will need before the visit.
- 2
On-site diagnosis
The technician checks the compressor, evaporator, defrost circuit and door gasket, then explains what he found and proposes the repair before starting any work.
- 3
Repair and reset
We fix the faulty part, reset the defrost cycle if needed, and test the freeze temperature and alarm after closing the unit.
- 4
Performance check and handover
We confirm the freezer reaches the right freeze temperature and the door closes tightly, then explain how to monitor performance over the next few days.
A proper repair or ignoring the fault?
| Alrabih | The usual way | |
|---|---|---|
| Diagnosis | Full check on site | Guessing the cause |
| Defrost cycle | Tested and reset | Left unchecked |
| Door gasket | Checked and replaced if needed | Worn seal left leaking |
| Frozen stock | Guidance to keep it safe | No advice given |
| Refrigerant | Pressure read from nameplate type | Added without measuring |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Al Aqeeq holds several hotels, entertainment centres and upmarket restaurants alongside modern residential areas. Freezers here run continuously under heavy load because of substantial daily demand and round-the-clock operations. Swift and precise maintenance is critical to avoid financial losses and service interruption.
Al Aqeeq sits in north Jeddah near hotels and tourist resorts, a modern commercial and tourism area.
Most large hotels and restaurants here use high-capacity industrial freezer systems with multiple units.
The AC setup in Al Aqeeq
- 1
Multi-unit industrial freezer systems
Large hotels and restaurants use multiple freezer units connected to a single central cooling system.
- 2
Long copper lines from condenser to freezers
Copper runs can be very long because kitchens sit far from outdoor units on hotel roofs.
- 3
Freezers placed in hot, cramped kitchens
Hotel kitchens are small and hot, putting constant thermal load on the freezers.
Before the visit
Before our visit in Al Aqeeq
- 1
Schedule the visit away from peak service hours
Coordinate with us beforehand to pick a time outside main kitchen hours to keep hotel operations running.
- 2
Clear the kitchen access path
Ensure the path from the kitchen entrance to the freezer is clear of obstacles and stored equipment.
- 3
Tell us where the outdoor unit sits on the roof
Identify where the condenser and outdoor unit sit on the roof so we can inspect them as part of the service.
More districts for Freezer maintenance
Other services in Al Aqeeq
FAQ
Questions about Freezer maintenance
Can the freezer be repaired without emptying it completely?
It depends on the fault. Checks on the compressor or an external sensor can be done without touching the contents. Repairs to the evaporator or defrost heater need the freezer emptied, and we tell you in advance and advise how to keep the stock in cool boxes while we work.
Why does my freezer compressor never stop running?
Three common causes: a worn door gasket letting warm air in, ice build-up on the evaporator reducing heat transfer, or low refrigerant. The technician checks all three during the visit and identifies the real cause before any repair.
Why does heavy frost keep building up inside my freezer even though the door closes properly?
The most common cause is a fault in the automatic defrost circuit, whether in the heater element, the timer or the temperature sensor. When this circuit fails, ice accumulates on the evaporator coil until airflow is blocked, cooling weakens and energy use rises. The technician identifies the exact cause by testing each component of the circuit in turn.
Do you service both chest and upright freezers?
Yes, we service both types in homes and shops. Chest and upright freezers share many components such as the compressor, evaporator and thermostat, but the defrost cycle design and coil position differ between them, and our technicians are trained to handle that difference in every case.
Does the freezer type, chest or upright, change how the repair is done?
Yes, in some steps. A chest freezer has the evaporator wrapped around the inner walls, while an upright has it at the back of the compartment with a fan. The position of the defrost heater and how to reach it differ between the two, so the technician needs to know the type before the visit to bring the right tools.
The kitchen freezer is losing cooling power quickly, what is wrong?
There may be a refrigerant leak or a blocked line. We inspect the full system to identify the cause and restore cooling swiftly.
The hotel is always busy, can you finish the service quickly?
Yes, we prioritise hotel and commercial jobs. We coordinate to pick a time away from peak hours and work with high efficiency to minimise operational impact.
Harsh summer heat seems to slow freezing speed, does that need extra maintenance?
Absolutely, intense outdoor heat raises compressor and condenser load significantly. We advise weekly condenser cleaning and monthly inspection of core parts to maintain performance.
The freezer's copper lines are very long, does that affect performance?
Yes, long lines can increase heat loss and pressure drop. We inspect the lines and insulation during service and ensure pressure and flow are optimal.
