Fitted right first time
Split AC installation in Jawharat Thuwal
In Jawharat Thuwal at Jeddah's far north on the Red Sea coast, split AC installation serves a growing residential community. Alrabih's team installs both units with high skill, runs insulated copper and correctly sloped drainage for safe, effective cooling from the start.
- Mueller copper
- Full vacuum
- Proper drain
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
When you need a proper installer
- 1
A new unit for a room or flat
You have bought the unit, or are about to, and want it fitted once, not to find a refrigerant leak or water on the floor a few weeks later. Getting it right first time saves you all of that.
- 2
Not sure where the outdoor unit goes
In Jeddah flats the choice is usually the roof, the balcony or the facade. We pick a spot where the condenser gets enough air, a technician can reach it for servicing, and neither noise nor drain water bothers the neighbours.
- 3
A past install that went wrong
Weak cooling since day one, water running down the wall, a loud indoor unit. These are usually installation mistakes, not faults in the unit, and our installation is built step by step to avoid them.
Who it's for
Moving into a new flat that needs AC
We plan every unit position and copper route in one go, so the whole flat ends up neat and consistent.
Ask on WhatsAppFitting AC in a shop or office
We place the units so cool air reaches the entrance and the work area, and arrange outdoor units and drains to suit the shopfront and the building's rules.
Ask on WhatsApp
What the installation covers
- Site check and unit positions
- Insulated copper, sealed wall core
- Drain line with correct fall
- Vacuum and leak test
- Start-up test with you present
How we work
How we work
- 1
Send a photo
WhatsApp us a photo of the room, where the outdoor unit might go and your district, and we tell you what the job needs before the visit.
- 2
Agree positions and route
On site, the technician agrees the unit positions and the copper and drain route with you before drilling any wall.
- 3
Fit and vacuum
We mount both units, run and insulate the copper, then vacuum the line with a pump and check the joints before releasing the refrigerant held in the outdoor unit.
- 4
Start-up and handover
We run the unit, measure the air coming out, check the drain flows, then leave the room clean and show you the remote and how to clean the filter.
A careful install or a rushed one?
| Alrabih | The usual way | |
|---|---|---|
| Vacuum | Pumped before start-up | Often skipped |
| Copper | Mueller, fully insulated | Patchy insulation |
| Drain | Falls, so no drips | Water down the wall |
| Outdoor unit spot | Airy and easy to reach | Wherever it fits |
| Wall opening | Sealed tight | Dust gets through |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Jawharat Thuwal is a fast-growing coastal residential community on the Red Sea shore with modern villas and apartments featuring spacious outdoor areas. The coastal location means direct exposure to salt spray, strong sea winds and very high humidity, demanding skilled fitting and extra-robust insulation for copper, wires and fixtures, plus effective drainage to prevent unit corrosion and leaks.
Jawharat Thuwal at Jeddah's far north on the Red Sea coast is a growing coastal residential district of modern villas and apartments.
Most outdoor units are mounted on roofs or sea-facing facades, meaning direct exposure to salt spray and wind.
The AC setup in Jawharat Thuwal
- 1
Split with outdoor unit on protected roof or facade
The outdoor unit is mounted on a roof or facade protected as much as possible from direct salt spray and sea wind.
- 2
Heavy-duty drainage for abundant condensation
The outdoor line is fitted with extra thickness and very heavy drainage to handle the high condensation volume from extreme humidity.
- 3
Salt and moisture-resistant insulation and fixtures
Copper, wires and metal are insulated and fitted with premium materials withstanding harsh coastal salt and moisture.
Before the visit
Before our visit in Jawharat Thuwal
- 1
Choose the most sheltered location from sea and salt
Select the outdoor unit's location on the side least exposed to the sea, strong winds and salt spray.
- 2
Confirm roof and exterior wall strength before mounting
Inspect building strength and materials, especially if exterior walls show salt or moisture damage, before drilling and mounting.
- 3
Identify safe drainage path away from foundations and neighbours
Choose a safe location for condensate drainage away from the building's foundation and neighbours' properties, and coordinate with management or neighbours if needed.
More districts for Split AC installation
Other services in Jawharat Thuwal
FAQ
Questions about Split AC installation
Will you install a unit I bought elsewhere?
Yes, we install units you have bought yourself. Before the visit we ask the model, its capacity and where both units will go, so we know the copper length. If you have not bought one yet, we are an authorised distributor for Carrier, YORK, General, Midea, Gree and Smart Gold and can help you choose.
Why does the line need vacuuming before start-up?
New pipes hold air and moisture, and Jeddah's humid air adds more. Mixed with refrigerant, they weaken cooling and strain the compressor over time. We pull them out with a vacuum pump, watch that the reading holds so we know the line is tight, and only then release the refrigerant.
Can the outdoor unit be far from the room?
Yes, within the manufacturer's limits for line length and height difference. We use Mueller copper in runs of up to 30 metres without welded joints, so there are fewer joints that could leak, and the survey shows whether a long run needs extra refrigerant.
Can you hide the copper and cables in the wall?
It depends on the house. In a new build or during finishing works, the copper can run inside the wall before plastering. In a lived-in home we use neat plastic trunking in the wall colour. We show you the better option for your home at the survey, before any work starts.
What if the outside wall cannot carry the unit?
We check the wall before fixing anything, because some facades are clad in stone or panels that cannot take the weight. Then we set the unit on a floor stand on the roof or balcony, or on a bracket anchored to the concrete itself, not the cladding, so it does not shake loose.
Salt and the sea are very close, do AC units rust quickly?
Yes, salt and high humidity accelerate corrosion significantly, so we use salt-resistant insulation and fixtures and recommend regular maintenance for prevention.
Sea winds are very strong, how do you secure the outdoor unit safely?
We use very heavy-duty metal fixings and wind-resistant brackets, choosing a location as protected as possible from direct wind.
Coastal humidity is very high, does this affect condensation and drainage?
Yes, very high humidity significantly increases condensation, so we install heavy-duty drainage and carefully vacuum lines before start-up.
Roofs and exterior walls are affected by salt and moisture, how do you ensure safe mounting?
We inspect materials and strength before drilling, use salt and moisture-resistant fasteners, and may choose a more sheltered location if the structure is weak.
