Warehouse HVAC in Al Sabeel

It depends on indoor humidity levels and the type of stock stored. In well-ventilated open areas where stock is not sensitive to a small rise in humidity, evaporative cooling can work well. The site survey gives a clear answer before any decision is made.

In a tall bay, cool air settles low and hot air rises, which works in your favour when diffusers are aimed correctly at the working level and the racking. We set diffuser angles and positions during design based on the racking height and the movement aisles.

Cold rooms and freezer rooms run on their own refrigeration systems, which we install as a separate service. What we handle here is the ambient air around those room doors, so warm warehouse air does not rush in when they open, managed by pressure zoning between the two spaces.

Yes, especially ducts that run close to the hot metal roof. Without insulation, cool air gains heat before it reaches the diffusers and loses much of its effect. We insulate with Armaflex or Kimmco materials and seal joints with Foster sealants to stop air leaks.

Yes. In tall racking aisles the airflow path narrows and slows, so we choose directional diffusers that push air along the aisle length rather than spreading it sideways. In open floor areas we use wider-angle diffusers. The angle and position of each diffuser are set at design stage based on the aisle width and racking height.

We specify cleanable metal filters instead of paper ones, and schedule maintenance every month or two depending on dust density.

Yes, thermal insulation can be added above or below the metal roof before cooling is installed, which significantly reduces the cooling load.

We select wind-resistant outdoor units with heavy-duty mounting on concrete frames, and ensure no obstruction disrupts airflow around them.

We assess your main power and existing generator first. If capacity is tight, we recommend an extra generator or dedicated circuit to ensure steady power.