Central AC installation in Abha, Asir Region
Central AC installation in Abha adapts to high altitude, cool winters and fog, offering efficiency and durability. We design a balanced system for your villa or building with reliable units and duct from our Jeddah workshop.
4.9 on Google- Design and build
- Own-workshop ducts
- Full commissioning
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
Is it for you?
Who needs a complete central system?
- 1
A new villa before finishing
The finishing stage is the right time to run central AC ducts before the ceilings close. Delaying the decision means extra cost later or compromises in the duct route that weaken airflow in certain rooms.
- 2
A commercial or office building
A commercial building needs airflow that fits how the floors are divided and how the load varies between levels. The site survey sets unit count, duct routes and outlet positions before any decision is made.
- 3
An old system draining power
Old units, deteriorating ducts and leaking copper push the electricity bill up without cooling the space properly. Replacing the whole system starts with a fresh load calculation, not with larger units pushed into the same old ductwork.
Who it's for
Building a villa and need ducts before ceilings close
We visit during the finishing stage, design duct routes and outlet positions, fabricate the ducts in our workshop and install them before the ceilings close, so you take over a fully working villa.
Ask on WhatsAppManaging a commercial building and replacing an old system
We recalculate the loads, design airflow to match the current floor layout and replace both units and ductwork completely so the system runs reliably without repeated faults.
Ask on WhatsApp
What the job covers
What the contract covers
- Load calc and system design
- Units from authorised distributors
- Duct fabrication and fitting
- Insulated Mueller copper runs
- Full commissioning and handover
How we work
How we work
- 1
Survey and load calculation
The engineer visits, measures each zone, and calculates the thermal load per area, accounting for facade orientation, ceiling height, intended use, and the building's conditions and its city's climate.
- 2
Design and unit selection
We draw duct routes and outlet positions and select units from Carrier, YORK, General, Midea, Gree or Smart Gold, then present the design to you before any work begins.
- 3
Fabrication and installation
Round and rectangular ducts are fabricated in our workshop from G90 galvanised sheet to SMACNA standards, then installed on site alongside the copper runs, insulation and electrical connections.
- 4
Commissioning and handover
We pressure-test the copper lines, vacuum them, check air balance at every outlet and condensate drain fall, then hand the system over to you in full working order.
Why Alrabih?
One contractor or several parties?
| Alrabih | The usual way | |
|---|---|---|
| Design and build | One party accountable | Designer and installer split |
| Ducts | Our workshop, G90 standard | Unmonitored outside suppliers |
| Copper | Up to 30 m, weld-free | Unknown source, many joints |
| Commissioning | Pressure test, vacuum, air balance | Straight power-on, no testing |
| Insulation | Armaflex and Kimmco fitted | Patchy or missing |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.

Split AC installation
Request this service
Duct installation
Request this service
Central AC installation
Request this service
Duct fabrication
Request this service
Cold room installation
Request this service
Electro-mechanical works
Request this service
Chiller & AHU installation
Request this service
HVAC design
Request this service
Copper piping works
Request this service
Air outlets and grilles installation
Request this service
Ventilation and exhaust systems
Request this service
HVAC controls and automation
Request this service
Duct insulation
Request this service
AC repair & faults
Request this service
AC cleaning
Request this service
Refrigerant charging
Request this service
Central AC maintenance
Request this service
Chiller maintenance
Request this service
AC removal & refitting
Request this service
Duct cleaning & sanitising
Request this service
AC servicing by brand
Request this service
Operation & maintenance contracts
Request this service
AHU maintenance
Request this service
Testing and commissioning
Request this service
Fridge & freezer service
Request this service
Cold rooms
Request this service
Display fridges & chillers
Request this service
Factory HVAC
Request this service
Warehouse HVAC
Request this service
Villa & home HVAC
Request this service
Hotel HVAC
Request this service
School HVAC
Request this service
Hospital HVAC
Request this service
Mosque HVAC
Request this service
Mall & retail HVAC
Request this service
Restaurant & cafe HVAC
Request this service
Government building HVAC
Request this service
Sports club HVAC
Request this service
Tower and office building HVAC
Request this service
University HVAC
Request this service
G90 galvanized steel and aluminium sheets
Request this service
Mueller and Lawton copper pipes
Request this service
Air grilles and diffusers (Saudi-made)
Request this service
Central AC accessories and materials
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we have completed.
Customer reviews
What our customers say
- Waleed Daadouch
“The nicest treatment from the showroom team, and their prices are very competitive.”
Translated from Arabic
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- RHAM rhamLocal Guide
“May God grant them success. Refined and respectful treatment.”
Translated from Arabic
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Shakeel Ahmed
“Nice experience very cooperative. Nice conducting with all customers”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewWhere we work
Central AC installation in cities near Abha
We are based in Jeddah, and we supply duct and install across the Kingdom. All our services in Abha
What sets this city apart
Abha is a high mountain city with modern villas on hillsides, resort hotels, residential and government buildings. Summers are cool and winters cold and damp with rain and fog, affecting AC design. Outdoor units need protection from humidity and fog, and duct requires careful drainage for possible moisture. Villas on slopes may have hard roof access, so outdoor units often sit on exposed walls. Larger buildings need careful load analysis for altitude and relative cool.
Abha is a high mountain city and capital of 'Asir region on steep slopes, with mild summers, cool damp winters with rain and fog, built of traditional and modern stone and concrete villas, hotels and apartments.
In Abha's hillside villas, outdoor units sit on exposed walls rather than roofs and need insulated duct with moisture drainage for winter damp.
The AC setup in Abha
- 1
Outdoor units on exposed walls
In Abha's mountain villas outdoor units go on exposed walls rather than roofs, with duct and pipes protected from fog and damp.
- 2
Insulated duct with moisture drainage
Abha's duct needs good insulation and precise drainage openings to prevent cold water pooling in pipes and outlets.
- 3
System optimised for altitude and humidity
Units are carefully chosen to handle altitude and high humidity, with high-quality filters and special periodic maintenance.
Before the visit
Before our visit in Abha
- 1
Provide site plans and altitude information
Send architectural plans and site photos, and tell us the altitude and slope, so we design the system for mountain conditions exactly.
- 2
Identify unit locations on the slope
Agree unit locations with the site engineer, noting available exposed walls and good airflow access for the outdoor unit.
- 3
Plan corrosion and moisture protection
Tell us about local climate conditions and any extra protection needed, so we choose materials and coatings resistant to fog and damp.
Other services in Abha
FAQ
Questions about Central AC installation
How do you decide the right unit size for my villa?
We calculate the thermal load for each zone based on its area, ceiling height, number of external openings, orientation and intended use, taking into account the building's conditions and its city's climate. We choose the unit size after this calculation, not before.
Do you make the ducts yourselves or buy them ready-made?
We fabricate round and rectangular ducts in our own workshop from G90 galvanised sheet or aluminium sheet depending on what the project needs. This lets us cut ducts to the exact site dimensions and fit them tightly, avoiding ill-fitting sections that leak air and raise electricity consumption.
What if the copper run to an outdoor unit is very long?
We supply copper runs of up to 30 metres without welded joints. If a run exceeds that, the survey determines whether the outdoor unit position needs rethinking or whether the refrigerant charge needs adjustment according to the type shown on the unit's nameplate.
Can each floor of the villa run on its own?
Yes, and it is settled at the design stage. Each floor can have its own unit, or the network can be split into zones with dampers and a thermostat in each, so you do not cool the whole upper floor while the family sits in the majlis. We recommend the right option after the load calculation.
Do the outdoor units need a special base on the roof?
Yes, and the roof surface determines what kind of base is needed. For villas we fabricate a raised steel frame that keeps the unit clear of pooled rainwater and allows airflow beneath it. The exact height and angle depend on the roof pitch and the condensate drain position, which the site survey establishes. The aim is to keep the unit level and to prevent vibration movement during operation.
Abha's cold and damp winters. Do they change central AC design requirements?
Yes, absolutely. Humidity and fog require outdoor units protected from rust and corrosion, and duct with precise moisture drainage. The heat load is also lighter than hot cities, so we choose moderate-capacity units that save power.
You are in Jeddah and Abha is high in the mountains. How do you deliver duct and units to me?
We visit the site or review the plans, study altitude and climate, design the system, fabricate the duct in our workshop to exact sizes, deliver it with the units to your Abha site, install, test and commission. The schedule is agreed in the quote.
Abha is at high altitude with winter fog. Does this affect system efficiency?
Altitude significantly reduces heat load, so units run more efficiently on less power. Fog and humidity require regular filter and condenser cleaning, but do not affect efficiency if maintenance is correct.
Abha's villas are on slopes. Where do the outdoor units go?
On Abha's slopes we mount outdoor units on exposed walls or flat ground areas rather than roofs, studying the site with you to find the best location for easy maintenance and airflow.


























































































