Central AC installation in North Corniche

We calculate the thermal load for each zone based on its area, ceiling height, number of external openings, orientation and how it will be used. In Jeddah the sun's effect on west-facing facades is significant, and high humidity goes into the calculation. We choose the unit size after this calculation, not before.

We fabricate round and rectangular ducts in our own workshop from G90 galvanised sheet or aluminium sheet depending on what the project needs. This lets us cut ducts to the exact site dimensions and fit them tightly, avoiding ill-fitting sections that leak air and raise electricity consumption.

We use Mueller copper in runs of up to 30 metres without welded joints, which reduces potential leak points. If a run exceeds that, the survey determines whether the outdoor unit position needs rethinking or whether the refrigerant charge needs adjustment according to the type shown on the unit's nameplate.

Yes, and it is settled at the design stage. Each floor can have its own unit, or the network can be split into zones with dampers and a thermostat in each, so you do not cool the whole upper floor while the family sits in the majlis. We recommend the right option after the load calculation.

Yes, and the roof surface determines what kind of base is needed. For villas we fabricate a raised steel frame that keeps the unit clear of pooled rainwater and allows airflow beneath it. The exact height and angle depend on the roof pitch and the condensate drain position, which the site survey establishes. The aim is to keep the unit level and to prevent vibration movement during operation.

Yes, central AC delivers consistent efficiency and comfort across the villa, especially with the high ceilings and open layouts here on the Corniche. We calculate the load based on floor area, insulation, windows and sun exposure, so we select the right unit precisely.

Yes, humidity and salt accelerate corrosion on copper and joints. We choose treated copper and reinforced insulation, and apply additional protective coating to all connections to extend system life in the coastal environment.

We visit the villa first and measure the roof, outdoor areas and proximity to main rooms. The unit typically goes on the villa roof or outer wall where it gets good airflow, and we balance cooling efficiency with noise reduction and visual impact.

The timeline depends on the villa's size, copper run length, number of rooms and building condition. We confirm the exact schedule in the quote after our site visit and measurements.