Central AC installation in Tabuk, Tabuk Region
Central AC installation in Tabuk bridges extreme dry summer heat and cool winters. We design complete systems for villas, apartment buildings and warehouses, choosing units that balance summer efficiency and winter flexibility.
4.9 on Google- Design and build
- Own-workshop ducts
- Full commissioning
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
Is it for you?
Who needs a complete central system?
- 1
A new villa before finishing
The finishing stage is the right time to run central AC ducts before the ceilings close. Delaying the decision means extra cost later or compromises in the duct route that weaken airflow in certain rooms.
- 2
A commercial or office building
A commercial building needs airflow that fits how the floors are divided and how the load varies between levels. The site survey sets unit count, duct routes and outlet positions before any decision is made.
- 3
An old system draining power
Old units, deteriorating ducts and leaking copper push the electricity bill up without cooling the space properly. Replacing the whole system starts with a fresh load calculation, not with larger units pushed into the same old ductwork.
Who it's for
Building a villa and need ducts before ceilings close
We visit during the finishing stage, design duct routes and outlet positions, fabricate the ducts in our workshop and install them before the ceilings close, so you take over a fully working villa.
Ask on WhatsAppManaging a commercial building and replacing an old system
We recalculate the loads, design airflow to match the current floor layout and replace both units and ductwork completely so the system runs reliably without repeated faults.
Ask on WhatsApp
What the job covers
What the contract covers
- Load calc and system design
- Units from authorised distributors
- Duct fabrication and fitting
- Insulated Mueller copper runs
- Full commissioning and handover
How we work
How we work
- 1
Survey and load calculation
The engineer visits, measures each zone, and calculates the thermal load per area, accounting for facade orientation, ceiling height, intended use, and the building's conditions and its city's climate.
- 2
Design and unit selection
We draw duct routes and outlet positions and select units from Carrier, YORK, General, Midea, Gree or Smart Gold, then present the design to you before any work begins.
- 3
Fabrication and installation
Round and rectangular ducts are fabricated in our workshop from G90 galvanised sheet to SMACNA standards, then installed on site alongside the copper runs, insulation and electrical connections.
- 4
Commissioning and handover
We pressure-test the copper lines, vacuum them, check air balance at every outlet and condensate drain fall, then hand the system over to you in full working order.
Why Alrabih?
One contractor or several parties?
| Alrabih | The usual way | |
|---|---|---|
| Design and build | One party accountable | Designer and installer split |
| Ducts | Our workshop, G90 standard | Unmonitored outside suppliers |
| Copper | Up to 30 m, weld-free | Unknown source, many joints |
| Commissioning | Pressure test, vacuum, air balance | Straight power-on, no testing |
| Insulation | Armaflex and Kimmco fitted | Patchy or missing |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.

Split AC installation
Request this service
Duct installation
Request this service
Central AC installation
Request this service
Duct fabrication
Request this service
Cold room installation
Request this service
Electro-mechanical works
Request this service
Chiller & AHU installation
Request this service
HVAC design
Request this service
Copper piping works
Request this service
Air outlets and grilles installation
Request this service
Ventilation and exhaust systems
Request this service
HVAC controls and automation
Request this service
Duct insulation
Request this service
AC repair & faults
Request this service
AC cleaning
Request this service
Refrigerant charging
Request this service
Central AC maintenance
Request this service
Chiller maintenance
Request this service
AC removal & refitting
Request this service
Duct cleaning & sanitising
Request this service
AC servicing by brand
Request this service
Operation & maintenance contracts
Request this service
AHU maintenance
Request this service
Testing and commissioning
Request this service
Fridge & freezer service
Request this service
Cold rooms
Request this service
Display fridges & chillers
Request this service
Factory HVAC
Request this service
Warehouse HVAC
Request this service
Villa & home HVAC
Request this service
Hotel HVAC
Request this service
School HVAC
Request this service
Hospital HVAC
Request this service
Mosque HVAC
Request this service
Mall & retail HVAC
Request this service
Restaurant & cafe HVAC
Request this service
Government building HVAC
Request this service
Sports club HVAC
Request this service
Tower and office building HVAC
Request this service
University HVAC
Request this service
G90 galvanized steel and aluminium sheets
Request this service
Mueller and Lawton copper pipes
Request this service
Air grilles and diffusers (Saudi-made)
Request this service
Central AC accessories and materials
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we have completed.
Customer reviews
What our customers say
- Waleed Daadouch
“The nicest treatment from the showroom team, and their prices are very competitive.”
Translated from Arabic
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- RHAM rhamLocal Guide
“May God grant them success. Refined and respectful treatment.”
Translated from Arabic
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Shakeel Ahmed
“Nice experience very cooperative. Nice conducting with all customers”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewWhere we work
Central AC installation in cities near Tabuk
We are based in Jeddah, and we supply duct and install across the Kingdom. All our services in Tabuk
What sets this city apart
Tabuk's built environment ranges from modern villas and apartment buildings in populated areas to warehouses, farms and fields on the outskirts, plus government buildings and hotels. Extreme dry summer heat demands powerful cooling units and tight duct insulation, while cool winters mean many zones may not need cooling most of the year. Design must account for this large temperature swing and allow winter energy savings.
Tabuk is a north-west city on a desert plateau ringed by mountains, with extremely hot dry summers and relatively cool winters.
A common setup in Tabuk is villas and apartment buildings with one or two AC units distributing cool air through duct to rooms, with an outdoor unit on the roof or a heat-protected wall.
The AC setup in Tabuk
- 1
Tightly insulated duct against heat
The duct is supplied with adequate insulation to prevent cool air loss as it crosses roofs and unconditioned spaces in Tabuk.
- 2
High-capacity cooling units on roof
Outdoor units are placed on the roof away from heat-absorbing walls, ideally shaded or protected from direct sun.
- 3
Flexible system for winter savings
The design allows individual zones to be switched off or reduced during Tabuk's relatively cool winters, keeping the system running at the building's actual load.
Before the visit
Before our visit in Tabuk
- 1
Send the villa layout and floor plan
Send the villa layout before the visit, so we calculate the heat load precisely and plan the duct route and unit positions based on room distribution.
- 2
Confirm the shaded outdoor unit position
Agree with the villa engineer on an outdoor unit position on the roof or a sun-protected wall and tell us before the visit.
- 3
Arrange material delivery and installation dates
Tell us the site entrance and space for unloading duct and equipment, and set installation and testing dates with us based on the site schedule.
Other services in Tabuk
FAQ
Questions about Central AC installation
How do you decide the right unit size for my villa?
We calculate the thermal load for each zone based on its area, ceiling height, number of external openings, orientation and intended use, taking into account the building's conditions and its city's climate. We choose the unit size after this calculation, not before.
Do you make the ducts yourselves or buy them ready-made?
We fabricate round and rectangular ducts in our own workshop from G90 galvanised sheet or aluminium sheet depending on what the project needs. This lets us cut ducts to the exact site dimensions and fit them tightly, avoiding ill-fitting sections that leak air and raise electricity consumption.
What if the copper run to an outdoor unit is very long?
We supply copper runs of up to 30 metres without welded joints. If a run exceeds that, the survey determines whether the outdoor unit position needs rethinking or whether the refrigerant charge needs adjustment according to the type shown on the unit's nameplate.
Can each floor of the villa run on its own?
Yes, and it is settled at the design stage. Each floor can have its own unit, or the network can be split into zones with dampers and a thermostat in each, so you do not cool the whole upper floor while the family sits in the majlis. We recommend the right option after the load calculation.
Do the outdoor units need a special base on the roof?
Yes, and the roof surface determines what kind of base is needed. For villas we fabricate a raised steel frame that keeps the unit clear of pooled rainwater and allows airflow beneath it. The exact height and angle depend on the roof pitch and the condensate drain position, which the site survey establishes. The aim is to keep the unit level and to prevent vibration movement during operation.
Do Tabuk's extreme temperatures require special cooling units?
Extreme dry summer heat calls for high-capacity cooling units. We select units based on a precise thermal load calculation for the site and insulate duct and pipes tightly to keep cool air reaching every room.
You are based in Jeddah, so how does the central system reach Tabuk?
We design the system based on villa or building requirements, fabricate duct in our workshop to approved sizes, supply it with units and materials to your Tabuk site, install and test it fully, with dates set in the quote.
Does central AC need adjusting for Tabuk's cold winters?
Cold winters mean you may not need cooling for several months. We design the system to allow shutting down zones or reducing capacity as needed, saving energy without losing summer flexibility.
What is the best position for the outdoor unit in a Tabuk villa?
The outdoor unit is placed on the roof or a high wall away from direct sun exposure, as high ambient temperatures affect unit performance. The exact position is decided after surveying the site and coordinating with the project engineer.


























































































